Wall mounted regulators

[aero-spaced-out]

Hi all,

Back again to melt heads.
I want to wall mount my reg(s)

I am about to put a stout on that I want to serve on 70/30 mixed gas.
I haven't got a mixed gas regulator yet and was considering the MK4 mixed gas reg.
I'm struggling to find a hose that have the appropriate end fittings for this.
I'm unsure if I'm just doing my research wrong or what but have literally turned up with zilch.
Other regs with hoses built in exist but for sake of consistency I would like to get the MK4 reg for mixed gas from Kegland...

Just due to the size of my space and where the bottles are going, I tried bottle mounting my CO2 reg and it really doesn't work for my spacing and setup especially if I am getting a 70/30 mixed gas bottle in the same space, so wall mounting my regs and running hoses too them is my best option

Has anybody got a mixed gas reg with a hose? Or have managed to source a hose that I can run from their mixed gas bottle to the reg?

If I need to get a different reg than the MK4 N2 reg for this that has a hose built in then so be it

Cheers

 

[Larse]

Just trying to understand what your issue is. That hose should fit the bottle no problem, DIN477 is the correct size and the other end will fit onto the regulator being a male DIN477, so no issue there. Then the regulator (assuming it's the Kegland N2 reg which works for mixed gas) seems to have a John Guest fitting that will take a 5/16" (8mm) gas line. What am I missing?

 

[aero-spaced-out]

Just trying to understand what your issue is. That hose should fit the bottle no problem, DIN477 is the correct size and the other end will fit onto the regulator being a male DIN477, so no issue there. Then the regulator (assuming it's the Kegland N2 reg which works for mixed gas) seems to have a John Guest fitting that will take a 5/16" (8mm) gas line. What am I missing?

The MK4 N2 reg has a different bottle fitting from the MK4 CO2 reg.
As far as I can see it's an incompatible fitting and would require a different hose.

This is the reg I would like to buy for mixed gas and am having zero luck trying to source a hose for:

https://brewkegtap.co.uk/products/kegland-mk4-beverage-nitrogen-regulator

I'm looking to see if anybody else has the N2 reg and of they have had any lucky sourcing a hose with appropriate Male and Female connectors on the end as I'm coming up dry.


EDIT:
I can see my mistake and the original post is misleading. I have edited it and hopefully it is a bit clearer.

 

[YeastFace]

If oredering from BKT, the barbed fitting in the picture will be replaced with a 3/8" push fitting.

3/8 push-fit output (this is different to the fitting shown