Brewzilla Gen 4 advice and experiences

[Davegase]

They really know how to charge for brewers
Not BKT they are just passing the cost on charged by Kegland

Maybe things will get cheaper when kegland Europe gets going.
MAYBE !!

 

[The Baron]

We can but hope Dave

 

[Brew_DD2]

We can but hope Dave

I think hope is all it will be if they base themselves on the continent (and why wouldn't they, right?). #brexitmeansbrexit

 

[Barone]

Is it possible to mash without the false bottom and the HED plate?

I wanted to make a BIAB type wort, with a bag of grains inside the mash tube

 

[Davegase]

Is it possible to mash without the false bottom and the HED plate?

I wanted to make a BIAB type wort, with a bag of grains inside the mash tuwoul would

Is it possible to mash without the false bottom and the HED plate?

I wanted to make a BIAB type wort, with a bag of grains inside the mash tube

I would say yes, but why wouldn't you use the false bottom and the heat deflection plate if you already have one ?

 

[Barone]

I would say yes, but why wouldn't you use the false bottom and the heat deflection plate if you already have one ?

because I think it would get too hot... burn the bag of grains

 

[Davegase]

because I think it would get too hot... burn the bag of grains

I don't see how two extra barriers between the heating element and the grain basket would cause the bag of grains to burn !
You did say that your intention was to use a bag inside the grain basket (mash tube).

 

[Africa_Craig]

I have the second pump controlled by a separate switch, have added a 3 way on the ascending recirculate to allow whirlpool and over the top recirculate or just one or other.
Whirlpool during mash mixes the wort in the space between maltpipe and kettle. Plus it flows over the temp sensor so that temp more accurate.
Second pump is for the counter flow chiller which enters as a second whirlpool.
I have also swapped out the original control unit for a smart PID controller this links into brew father, Adds WiFi control and second temp sensor that I use to measure recirculate wort temp or the outflow from CFC.

Thats quite a setup you. #Drooling :). As I bypassed the pump for my tap, thinking I am going to replace the tap with a camlock valve and then connect my older pump to that as a backup. As I have already upgraded the recirc pipe to the site glass, I have the old one I can rig as a backup setup.. Something like this. Can also then upgrade the pump.