Quick JG adapter fitting question - 1/4 BSP?

[conorm]

Hi.

I have this pressure gauge : https://www.amazon.co.uk/dp/B0C1Z5Y9XJ

And want to connect it up to my corny keg lines. I use 3/8" OD lines. Am I correct in thinking that this will do the job? https://www.amazon.co.uk/gp/product/B00CAGPNM2

Either that or a reducing female to male bush/nipple combo straight on to a ball lock disconnect, that I can't figure out either.... this is a new world for me.

 

[Buffers brewery]

1/4 FFL is not the same as 1/4 BSP. The gauge has a tapered male thread but will fit a this…

https://www.ebay.co.uk/itm/352389338741?var=621745991416

Don’t over tighten.

The FFL thread will fit a threaded quick connect

 

[conorm]

Thanks, I had my doubts about the different threads!

So what's the thread size on a quick connect, e.g. a ball lock disconnect on my corny?

 

[Buffers brewery]

Thanks, I had my doubts about the different threads!

So what's the thread size on a quick connect, e.g. a ball lock disconnect on my corny?

If you check out the Malt Miller site…
https://www.themaltmiller.co.uk/product/keg-disconnect-gas-in-thread/
They refer to the thread as 7/16 thread. The thread is also referred to as 1/4 FFL….
https://www.kegoutlet.com/what-does...1vjZNAANuUtaiqIuNb5KfkkaQzFEmF5B3uL8tLQcfcMhM
You can see a 1/4 FFL has a 7/16”- 20UNF thread, hence the reference to 7/16.

 

[peebee]

Careful. I think the conversation has slipped onto "FFL": The gauge still has a 1/4"BSPT thread. I think you are after one of these (they are surprisingly difficult to find, JG don't seem to do them, shop about a bit, consider a new gauge with 1/8" BSP thread) : https://www.advancedfluidsolutions....ting-imperial-nylon-tube-connector-4015-p.asp

 

[Buffers brewery]

Careful. I think the conversation has slipped onto "FFL": The gauge still has a 1/4"BSPT thread. I think you are after one of these (they are surprisingly difficult to find, JG don't seem to do them, shop about a bit, consider a new gauge with 1/8" BSP thread) : https://www.advancedfluidsolutions....ting-imperial-nylon-tube-connector-4015-p.asp

Hi @peebee . See my post #2 for a plastic version

 

[conorm]

I've bought a 3/8 BSP to 1/4 push fit off ebay, closest I could find. Just now need a 1/4 to 3/8 bush which I can pick up at local plumbing merchant, and a length of 1/4 OD tube which I'm sure I have anyway.