Inkbird dual digital PID wiring

[BeerCat]

I was lucky enough to win one of these (thanks Inkbird) but been struggling a bit trying to figure out whats best to use it for, exactly how to wire it up and what sort of box to put it in. So i thought i would start a thread for anyone else struggling to get their heads around wiring up a PID

https://www.amazon.co.uk/dp/B00HVA23CK/?tag=skimlinks_replacement-20

After a search i came across this which is reasonably easy to follow.
[ame]https://www.youtube.com/watch?v=DZDkrR0Vhrc[/ame]

What i did notice though is they connect it to a light (heater) but don't show you how you would connect it to a fridge.
I will either be using it to control the mash temps with my ace boiler which will be customised with a recirculating pump or the keezer i hope to get soon.
I also have an STC1000 so not worried about what i use for either.

This is also good [ame]https://www.youtube.com/watch?v=yUFSMk8KVK4[/ame]

One thing i need to get is a suitable box. Was also thinking of adding an analogue amp meter and maybe an on/off switch.
Another thing i need to buy is the wire, can anyone point me in the right direction?
I have a leccy mate buy he isn't local so i plan to build it and will probably get him to give it the once over before i use it.

 

[GermLish]

I bought this stuff:

Switch: http://www.ebay.co.uk/itm/281313974967
Heatsink: http://www.ebay.co.uk/itm/152142247631 (+ 2xM5 screws)
Waterproof senor: http://www.ebay.co.uk/itm/182147398743 (optional, is more accurate)
Box: http://www.maplin.co.uk/p/plastic-box-mb6-matt-black-220x150x64mm-yn39n (although it's a tight fit)
Socket: http://www.maplin.co.uk/p/13a-hard-wearing-trailing-single-socket-black-vj84f
Plug: http://www.maplin.co.uk/p/13a-rough-service-mains-plug-black-nh65v

13A terminal blocks: http://www.maplin.co.uk/p/15a-terminal-blocks-3-pack-l98ar

 

[BeerCat]

Thanks for the info. I had forgotten that i will need a heatsink as well. Think i will get a larger box than you to avoid lots of swearing. I found a rocker switch in the cupboard so once i get all the bits i will have a go at putting it together. Its been a headache but good to learn something new. Just hope i can do a decent job of cutting out the holes .

 

[Inkbird]

Good share,thanks so much!

 

[BeerCat]

After months of scratching my head i finally wired up the ITC today. I watched the Inkbird video about 5 times and went for it. Looking forward to testing this out soon. Have a few more parts to add.