The saga begins

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
ok as previously stated user error is probable so fully suspecting insufficient mixing may be the culprit.
however confused with regard to refractometer as it has a sg scale on it so i would have presumed (yes presumption is the mother of all muck ups) that the measured sg's from the two devices would/should be similar.
if this is not the case is there definative guide i could be pointed in the direction of ?.

i do appreciate all help.
john
 
ok as previously stated user error is probable so fully suspecting insufficient mixing may be the culprit.
however confused with regard to refractometer as it has a sg scale on it so i would have presumed (yes presumption is the mother of all muck ups) that the measured sg's from the two devices would/should be similar.
if this is not the case is there definative guide i could be pointed in the direction of ?.

i do appreciate all help.
john
If it's insufficient mixing, the denser liquid would fall to the bottom of the fermenter. So in effect you would have two 'layers' of wort with different SGs. If you're taking your samples from the bottom, then the readings would be higher and if from the top, lower.

You could test this hypothesis by doing exactly that. Taking samples from both layers if possible.
 
yes all measurements have been from the tap except for og measurement before adding yeast. i shall take readings from top and bottom later today.
 
okay took a sample from top of brew reading is the same as from tap. any further suggestions would be a boon.
or should i just bottle and hope ?
 
The only other likely reason is the yeast. Don't know what yeast is included with that kit, should be a lager yeast, but they often use an ale yeast instead because lager yeasts generally need lower temperatures to work and a beginner would likely not have the kit to control a low temp.

Edit: Have looked up that kit and fermentation temp is 18°-24°, so could be a lager yeast although on the high side for that. More likely ale. Did the beer develop a high krausen (head) when fermenting initially?
 
to be honest once the lid went on i did not open it till today. all draw off for measurements was done through the tap.
 
to be honest once the lid went on i did not open it till today. all draw off for measurements was done through the tap.
That can be problematic as the draw off can pull the liquid out of the airlock and into the beer. Then you've no longer got an airlock.
 
Back
Top