djcorbetto
Well-Known Member
- Joined
- Jun 6, 2013
- Messages
- 146
- Reaction score
- 0
I've pretty much completed my heat exchanger for my brewery. any suggestions on connectors or an adaptor so I can fit cam locks on it
My Herms heat exchanger
- Thread starter djcorbetto
- Start date
Help Support The Homebrew Forum:
djcorbetto
Well-Known Member
- Joined
- Jun 6, 2013
- Messages
- 146
- Reaction score
- 0
Oh my photos aren't showing
- Joined
- Oct 17, 2011
- Messages
- 4,116
- Reaction score
- 984
there u go
15mm compression to 1/2" bsp brass conectrs would do it if thats 15mm copper coiled?
evanvine
Landlord.
Looking good, what's the pot volume?
+ can we see the coil inside the pot?
You don't need connectors, just Vossy's silicon hose!
+ can we see the coil inside the pot?
You don't need connectors, just Vossy's silicon hose!
djcorbetto
Well-Known Member
- Joined
- Jun 6, 2013
- Messages
- 146
- Reaction score
- 0
Thanks fil
The pot holds 6 litres so maybe slightly more than is really needed for a heat exchanger but I have been tempted to put something in the middle of the coil to reduce the volume.
I have a thing for making it all tidy so just putting pipe work on May not go with my ethos. I need to buy some hose anyway so a good excuse
The pot holds 6 litres so maybe slightly more than is really needed for a heat exchanger but I have been tempted to put something in the middle of the coil to reduce the volume.
I have a thing for making it all tidy so just putting pipe work on May not go with my ethos. I need to buy some hose anyway so a good excuse
