Mash Tun, Done!

[Cussword]

It's finished :party:

It's rather large

Made an insert

Manifold (took ages with a Dremel)

Then I made this, took two minutes

The manifold leaves 500Ml, the braid leaves 400ml
Finished

 

[Dieseljockey]

Bigger than mine Cuss :lol:

Snap on the braid manifold...don't take 5 mins to knock one up :thumb:

Nice big tun


Edit...Did you sort out BB...now the tun's done looks like a brewday coming up :clap:

 

[Tony]

Nice work Cuss ... love it. Bet you're dying to christen it!

With the manifold, can you flip it over so the slots are underneath?

:

 

[Cussword]

Yep, I only had it that way up to show what had been done.
If you want a laugh, I've converted a Burco Boiler that I'd bought off Aleman to a bottom tap,
& I found a stainless steel tray in the pound shop that I thought I'd make a false bottom of. So I drilled for what seemed like hours.

The damn holes are too big,
Back to the pound shop I will go
BTW that's Mrs C's tape measure, not mine

 

[Cussword]

Edit...Did you sort out BB...now the tun's done looks like a brewday coming up :clap:

Yep, got it now, but not through the link at the top of the page :wha:

 

[Tony]

Yep, I only had it that way up to show what had been done.

The damn holes are too big,

Ah yes .. good plan, sorry!

You must have worn out a couple of drills there! But the silver lining being it was only a quid purchase! I've just got another baby burco ... already converted one but can't remember what size tap I bought! *cough*arse

 

[31bb3]

Very nice that :thumb:

 

[Dieseljockey]

Bugger that...after all the time...I think the nearest pound shop to us is Evesham.

by the way nice tape measure, (they all say that) :rofl:

ps..when I tried BB the link was ok :thumb: