Ispindel help

[Jonco]

Just started a brew and the first few temperature readings are showing 0.0, was reading room temp prior the dropping it in, any ideas what could be wrong with it?

 

[Rwilts]

Is everything else showing correctly?

 

[Jonco]

Is everything else showing correctly?

Yes first 5 battery and gravity readings are what I would expect

 

[Rwilts]

I haven't experienced this myself (I do use an ispindele) @gingerneil is one of the resident experts. Hopefully it will resolve itself before he sees this.

 

[Jonco]

I haven't experienced this myself (I do use an ispindele) @gingerneil is one of the resident experts. Hopefully it will resolve itself before he sees this.

That's where I purchased them from, been spot on until now

 

[Agentgonzo]

I've had that occasionally.. Turn it off and on again. Seriously.

Sometimes it takes a few times. No idea why it does it. I check it is reporting temperature correctly currently before chucking it into the fermenter

 

[Rwilts]

I've had that occasionally.. Turn it off and on again. Seriously.

Sometimes it takes a few times. No idea why it does it. I check it is reporting temperature correctly currently before chucking it into the fermenter

It's already in the fermenter, I would leave it alone

 

[Agentgonzo]

It's already in the fermenter, I would leave it alone

Depends how urgently Jonco wants the temperature readings. I've sprayed my fingers with starsan, plucked it out of the fermenter on day 1, restarted it (checked it was reporting temperature), sanitised it again and dropped it back in no problems.

If it was at the the of fermentation, then I wouldn't do it.

 

[Rwilts]

Fair enough, just with the op being new may want to limit possible issues ...

 

[Jonco]

I've had that occasionally.. Turn it off and on again. Seriously.

Sometimes it takes a few times. No idea why it does it. I check it is reporting temperature correctly currently before chucking it into the fermenter

Yeah was absolutely fine, will have to wait now as in a pressure vessel

 

[Stu]

Yeah was absolutely fine, will have to wait now as in a pressure vessel

OK, so these aren't recommended in pressure vessels.

So here's my experience:

1. Make sure it's tight. Really right. Because pressure does strange things to rubber grommets.
2. Don't believe it. Again, these aren't recommended nor tested under pressure. The gravity is always slightly out.
3. It might just be me, but don't cold crash it. Mine simply stopped working. It's working now, so I didn't kill it, but it just stopped sending results.