Cooker hood filters...

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Clint

Forum jester...🏅🏆
Supporting Member
Joined
Jun 29, 2016
Messages
18,886
Reaction score
17,071
Location
North Wales
Hello all,
I have a 100cm wide cooker hood with three clip on mesh filters..they've been in the dishwasher a few times and oxi but it's time to replace them..
I can find loads on eBay..but I'm struggling with exact dimensions..
Mine are 318x258mm, tab spacings are critical..front end 100 mm In each side and 45mm between tabs. Back end 50mm in each side and 123mm between tabs..
I can find 320x 260 with my tab spacings but not 320x260!
Is the L X W critical as there is a tiny bit of play there?
Confused yet?
It's a Howdens hja2460..this part brings up wrong sizes..
 
Can you post a photo? Their brand is Lamona. Can you measure the gap? I think the 2mm difference is just wiggle room.
 
Last edited:
Cheers Kelper...it's defo 2460..I got all the paperwork and there's a sticker inside the hood..I think the 2mm difference don't matter..BUT...I'm not ordering until I find out..
 
Same cooker hud as mine, only mine is 2 filters not 3 and I soaked them last night and cleaned.
 
Lads if u can source some ubik from a company called clover it's based in England it's the best and safest degreaser u can get your hands on soak them and then hotwash in dishwasher they should be grand
 
Back
Top