I have a BZ 3.1.1
I've been using it without issue for just under 2 years.
I will very often set the preset to preheat the water with a time offset of, say, 10 hours, so I set it all up the night before and by the time I get up, the strike water is up to temp.
Last night, I came to do the same, but as soon as I pressed Play, the elements switched on. They would normally do nothing until the timer had counted down the, say, 10 hours. [Edit to add, it does the same in both automatic modes]
I re-read the section in the manual, even though it's not that hard and I have been using it this way for ages. I also made sure that the other presets were set to 00:00 so they would be ignored.
Has anyone heard of this issue / fault? Is there something obvious I may have missed in setting it up?
I have email BKT and I am awaiting their reply, but I thought I'd ask here in case anyone else has experienced this behaviour.
Many thanks.
I've been using it without issue for just under 2 years.
I will very often set the preset to preheat the water with a time offset of, say, 10 hours, so I set it all up the night before and by the time I get up, the strike water is up to temp.
Last night, I came to do the same, but as soon as I pressed Play, the elements switched on. They would normally do nothing until the timer had counted down the, say, 10 hours. [Edit to add, it does the same in both automatic modes]
I re-read the section in the manual, even though it's not that hard and I have been using it this way for ages. I also made sure that the other presets were set to 00:00 so they would be ignored.
Has anyone heard of this issue / fault? Is there something obvious I may have missed in setting it up?
I have email BKT and I am awaiting their reply, but I thought I'd ask here in case anyone else has experienced this behaviour.
Many thanks.
Last edited: