manifold/strainer

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
That is simple at the end of the vid it was mentioned about drilling out the hole on the inside to 10mm would this have to be done to accomodate the manifold
 
The fitting on the inside will take a 3/8" -> 1/2" Bush . . . which a 1/2" Straight tap Connector would screw onto . . . and you manifold will then push fit into the 15mm end. . . . The one I tried and didn't fit was 3/8" Tapered not parallel otherwise I would have included that on the vid
 
Back
Top