Kegerator Finished!!!

[dx4100]

Three dodgy STC1000 units later my Kegerator is finished and pouring beer

On the left is my Sierra Nevada Pale Ale All Grain Clone and on the right is John Bull IPA Kit which isn't half bad for a kit!

Chuffed doesn't even describe it

 

[Imperial]

Wow looking real good once I've twisted the wife's arm a few times I may invest in doing the same,also got to get rid of the kids as well to gain a spare room.

 

[Fil]

Very Nice.. u might wanna think about a drip tray, a cheap plastic planting trough sat on the floor can do it ..

 

[kev]

Nice gas mgmt board.

Where did you get it?

K

 

[dx4100]

normannumpa on ebay....

My only complaint about it is the dials are too high of a range really so it makes it tricky to set. Its more than doable just not ideal. You can replace the dials but it seemed expensive. :) I will make do :P

 

[Fil]

fyi dont try pulling the dials of those regs unless u need to they are sealed with a thread locking compound, to remove the leaky gas hose from mine i needed to employ a big lad for mass to hold the board against the wall it was bolted to while i used a 300mm wrench and 4ft pipe as a lever to budge the nut...

an inline gauge is much easier to fit in the post reg gasline.

 

[peelman]

Nice taps. Where did you get them from?
:thumb:

 

[Steam brew]

Lovely set up it looks great how long and what size is your beer line :

 

[dx4100]

fyi dont try pulling the dials of those regs unless u need to they are sealed with a thread locking compound, to remove the leaky gas hose from mine i needed to employ a big lad for mass to hold the board against the wall it was bolted to while i used a 300mm wrench and 4ft pipe as a lever to budge the nut...

an inline gauge is much easier to fit in the post reg gasline.

I already removed and put them back on. It was on very tight but it came off and went back on without much issue in the end. Cheers for the warning though :thumb:

 

[dx4100]

Nice taps. Where did you get them from?
:thumb:

Got lucky and found them on fleabay.... :)

 

[dx4100]

Lovely set up it looks great how long and what size is your beer line :

Cheers :) they are both 3/16 and 3 meter long :). No problem pouring :)

 

[boab42stout]

well done theres no stopping you now :