Reply to thread

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Run a fine file around the tap 2 or 3 lines up, using a hairdryer heat the pipe pushing the end of a kitchen utensil to help keep form then slide it over gently continuing to use the heat. Once in place splash with some cold water to help shrink then secure with a cable tie or a piece of wire.

You could also Smear some epoxy resin over the tap before putting on the hose and is only £1 in B+M or a poundshop.


Back
Top