Boiling Ring Cut Out

[shroppie]

Hi All,

I have a Lincat Lynx 2kw. boiling ring which should allow the use of a boiling pot without resorting to a kettle or immersion element in the
wort.
It does however need the thermal cut out removing. I am quite happy
to do this but I need to know which bit wants removing. ie.what does
it look like.
Any help would be most welcome.

shroppie

 

[Fil]

here is an ebay ad with a pic of one.

http://www.ebay.co.uk/itm/140oC-N-C...al_Components_Supplies_ET&hash=item5d48744521

to bypass just pull the wires off each spade and connect to eachother, power off first of course many people with buffalo.burco boilers upgrade them to a higher temp so the rolling boil is achievable but the boil dry protection remains intact.

 

[shroppie]

Many thanks for your reply.
This particular unit does not appear to have the cut out you describe.
The Lincat spare parts page for this unit does not mention a cutout at all!
Very odd?
Thanks shroppie

 

[darrenwest1]

how do you know it has a thermal cut out

surly it has a thermostat that allows the plate to reach the correct temp depending where you turn the dial to ?

 

[shroppie]

It does have a rotary switch which when turned raises or lowers a set of contacts allowing more or less current to the element.
The insides of this unit can be seen on Lincat Electric Boiling Ring Spare Parts.
The model is as above, the single 2kw. Lynx 400 range.

Thanks shroppie

 

[darrenwest1]

pull the cover off and have a look
or post a pic