Larse's latest activity

Well you don't actually need the spunding valve reg. You could use the manometer in your scenario instead.

Pinch

This seems a bit more complex than the one I had envisaged? The spunding valve is fully open, but the pressure into the destination keg...

Gorilla glue recommend using warm soapy water to remove all of their glues including epoxies. For a large area cover it with a towel...

No problem. I think you might have missed my reply to your question about the inline regulator though. Just above the one you replied to.

Is it advisable to push liquid through a spunding valve? Or am I misunderstanding the proposed setup?

It's a regulator. Gauge side is output. If you want to measure the input side, you could just add a spunding valve with the regulator...

Duotight make an inline regulator. Would that fit the bill?

It was the fulcrum that was evading me ;-)

The slower cooking time in a domestic oven will dry out the pizza dough too much.

Pro tip. If you're using your domestic oven, use more hydration in your dough. Pizza oven dough is usually 60% hydration, you can go to...

The other thing I've discovered is that regulator manometers are often very variable in their accuracy. Especially at the lower...

As said above, diameter and length is crucial. I've found a lot of the online calculators are a bit shy on the length. The one on...

It does if it's unionised.

No problem. I'm sure the law of the lever would have occurred to an engineer sooner or later. ;)