Obtaining bottles

The Homebrew Forum

Help Support The Homebrew Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Recycling is the answer. Most places well save them for you.
I have also made withdrawal from bottle banks šŸ˜

Labels :
Plastic ones need heat, put a pan on and stand them in it.

Paper ones might just float off. Look at the back of the label. If you can see lines... This is water badges glue. Overnight dual in cold. Bingo.
 
Some paper labels have a plastic film, peel that off then soak in hot PBW and the rest peels off with a sharp straight edge such as Stanley knife blade.
Plastic labels warmed in bowl of hot water for a minute or two then peel off in one go.
Final residue if any I use orange solvent and a scotch pad.
 
What does the PBW bring to the party?
Helps to get paper label off better than just water and at same time is part of cleaning my bottles.
WD40 needs detergent to get rid of as oil based, I like to keep petrochemicals and detergents away from my beer process.
But I'm sure it works great to get the glue off, keep using it.
 
If the labels don't come off with just hot water they stay put.
Also an update....I've since had 2 bottles in the same batch fail. The bottom looked like it had been cut off!
 
How do you get the labels off ? I soaked mine in warm soapy water but some are murder to remover .
As others have said it varies depending on the label. Instead of using my good PBW sometimes I just use a cheap oxy-type laundry detergent. Fill the sink with hot water and detergent, sink or stand the bottles so the label is covered and leave.
All going well the labels come off, but if not it's a scrape with the back of a butter knife and clean any residue with stainless pot scrub. De-solv-it a citrus based solvent will remove any sort of glue residue from plastic labels...

Then a good clean with PBW and bottle brush in a battery drill, rinse well and drain upside-down till dry. I cover the tops of clean bottles with tin foil and put them in crates, so I know they just need a pre-bottling rinse with starsan...
 
We are a rodent less after chief hunter Butter the Cat left a great big rat outside the door last night!
It was still warm when I bagged and binned it.
 
How do you get the labels off ? I soaked mine in warm soapy water but some are murder to remover .
I was always told never to put soap anywhere near a homebrew bottle as it can affect the head. I only use steriliser. Not sure how true this is. I leave labels on. Makes the bottles less slippery when wet.
 
Apart from the "Self Adhesive" type labels. I soak my bottles in washing up liquid and Oxyclean (poundshop version unfragranced). They usually float off. Bottles need a good rinse afterwards as the Oxyclean leaves a white residue behind.
 

Latest posts

Back
Top